HP LaserJet M9059 Multifunction Printer series - Manual (Page 114)

Staple documents
NOTE: Stapling features are only available if the stapler/stacker or multifunction finisher are attached
to the MFP.
Set the stapler at the control panel for printed jobs
You can usually select the stapler in your software program or printer driver, although some options
might be available only in the printer driver. See
Change printer-driver settings for Windows
on page 53 for more information. Where and how you make selections depends on your program or
driver. If the stapler cannot be selected in the program or printer driver, it can be selected using the MFP
control panel.
1. Scroll to and touch Administration .
2. Scroll to and touch Device Behavior .
3. Scroll to and touch Stapler/Stacker or Multifunct. Finisher .
4. Touch Staple .
5. Touch the staple option you want to use.
NOTE: Selecting the stapler at the printer control panel changes the default setting to Staple . It is
possible that all print jobs will be stapled. However, settings that are changed in the printer driver override
settings that are changed at the control panel.
Set the stapler at the control panel for all copy jobs
NOTE: The following procedure changes the default setting for all copy jobs.
1. Scroll to and touch Administration .
2. Touch Default Job Options .
3. Touch Default Copy Options .
4. Touch Staple/Collate .
5. Touch Staple .
6. Touch the staple option you want to use.
Set the stapler at the control panel for a single copy job
NOTE: The following procedure sets the stapling option for only the current copy job.
1. Touch Copy .
2. Touch Staple/Collate .
3. Touch the staple option you want to use.
100 Chapter 7 Print tasks ENWW