HP LaserJet M9059 Multifunction Printer series - Manual (Page 22)

Output devices
This MFP comes with a 3000-sheet stacker, a 3000-sheet stapler/stacker, a multifunction finisher, or
an 8-bin mailbox.
3,000-sheet stacker
● Stacks up to 3,000 sheets of A4- or letter-size paper
● Stacks up to 1,500 sheets of A3- or ledger-size paper
● Can offset jobs, or offset the first page of jobs
The lower bin (face-down bin) is the default bin for all output jobs.
3,000-sheet stapler/stacker
Paper handling features
● Stacks up to 3,000 sheets A4- or letter-size paper
● Stacks up to 1,500 sheets of A3- or ledger-size paper
● Can offset jobs, or offset the first page of jobs
The upper bin (face-up bin) is the default bin for all output jobs.
Stapling information
The 3,000-sheet stapler/stacker can staple documents that contain between two pages and 50 pages
of 75 g/m2 (20 lb) paper, or equivalent 5 mm (0.2 inches). The pages must be 64 to 199 g/m
2 (17 to 53
lb) of all sizes that the MFP supports.
● Heavier media might have a stapling limit of fewer than 50 pages.
● Stapling will not be performed on less than two sheets or more than 50 though the MFP will copy
or print the job.
Stapling is usually selected in your software program or printer driver. See Change printer-driver settings
for more information. Where and how you make selections depends on your program or driver.
If the stapler cannot be selected in the program or printer driver, it can be selected through the MFP
control panel. See
Staple documents on page 100 for instructions.
Multifunction finisher
Paper handling features
● Stacks up to 1,000 sheets of A4- and letter-size paper or up to 500 sheets of A3- and 11 x 17-size
paper
● Stacks up to 40 booklets of 5 sheets of A3- and ledger-size paper
● Can offset jobs
● Staples up to 50 sheets of paper per document of A4- and letter-size paper
8 Chapter 1 Product Basics ENWW