Setting auto raid 0 – HP Smart Storage Administrator User Manual
Page 42
Operations 42
•
All existing logical drives in the source array must be in OK state.
•
The destination array must have sufficient capacity to hold all logical drives present in the source array.
Setting Auto RAID 0
CAUTION:
If you select this option for any logical drives, you will experience data loss for that
logical drive if one physical drive fails. Assign RAID 0 to drives that require large capacity and
high speed, but pose no data safety risk.
Auto Array RAID 0 creates a single RAID 0 volume on each physical drive specified, enabling the user to
select multiple drives and configure as RAID 0 simultaneously. Each array contains one physical drive and
one RAID 0 logical drive.
For more information about RAID 0, see "RAID 0—No fault tolerance (on page
)."
To create an array with RAID 0:
1.
Open HP SSA.
For more information, see "Using the HP SSA GUI (on page
)."
2.
Select the controller.
3.
Click Create Arrays with RAID 0.