Encryptionclearconfig, Encryptioncryptopasswordset, Encryptionkeymanager – HP Smart Storage Administrator User Manual
Page 89: Encryptionmasterkey, Encryptionpassword, Encryptionrecoveryquestion, Encryptionrecoveryanswer, Encryptionrekeycontroller, Encryptionuser
Operations 89
EncryptionClearConfig
This command deletes all secrets and Critical Security Parameters from the controller. This command does not
delete or modify any existing logical volumes. However, if the volumes are encrypted, they will be placed
into an offline state by the controller.
If any encrypted logical volumes exist on the controller, this command must be run offline.
To run this command, enter the value KeyName. The KeyName is required if encrypted logical volumes exist
on the controller. Otherwise, this argument can be omitted.
EncryptionCryptoPasswordSet
This command sets the encryption password for the Crypto user role. The command value is the password.
EncryptionKeyManager
This command sets the Key Manager mode to either Local or Remote. If set to Remote Key Manager mode,
ensure the external configuration is set up properly on the server's iLO configuration screens, and the system
configuration is added to the remote key manager.
Command values:
•
Local key manager mode: Local
•
Remote key manager mode: Remote
EncryptionMasterKey
This command sets the initial Master Encryption Key name. The command value is the key name.
EncryptionPassword
This command provides the encryption password for the role selected under EncryptionUser (on page
).
The command value is the user password.
EncryptionRecoveryQuestion
This command sets the controller recovery question. The controller recovery question is used when the user
has forgotten the Crypto user password and wishes to change it. Enter the question as the value.
EncryptionRecoveryAnswer
This command sets the controller password recovery answer. This is the answer to the question set through the
EncryptionRecoveryQuestion command ("
" on page
). Enter the answer as
the command value.
EncryptionRekeyController
This command rekeys the controller when the value Yes is entered.
EncryptionUser
The commands User or Crypto set the encryption user role. The selected role determines which encryption
commands are available. Currently the only two roles supported are User and Crypto.