HP Smart Storage Administrator - Manual (Page 52)

Operations 52
physicaldrive 1:1:2 (port 1:box 1:bay 2, SAS, 36 GB, OK)
physicaldrive 1:1:8 (port 1:box 1:bay 8, SAS, 9.1 GB, OK)
physicaldrive 1:1:10 (port 1:box 1:bay 10, SAS, 9.1 GB, OK)
physical
physicaldrive 1:1:11 (port 1:box 1:bay 11, SAS, 9.1 GB, OK)
Displaying the current versions of the application layers
The version command displays the current versions of the application and other software layers.
Syntax:
version
Example command:
version
A typical output would be:
HP SSA CLI Version: 1.XX.X.X
SoulAPI Version: X.X.XX.X
InfoManager Version: X.0-XX.0
The help command
To get help with the CLI, enter help at the CLI prompt, and then enter one or more help items, as follows:
=> help <item1> [item2] [item3]
A help item can be any of the following:
• A CLI command (" The <command> variable " on page 48 )
• An HP SSA CLI keyword or keyword abbreviation
• A CLI parameter
• A term commonly used in HP SSA, such as migrate, extend, or cache
• The word shorthand (gives a list of abbreviations for keywords in the CLI)
The help feature of the HP SSA CLI behaves like a browser search engine in that each item that you add to
the help input string reduces the amount of help output text. For example, help controller produces
extensive information, while help controller remove restricts the help output to information about how
the remove command applies to controllers.
Typical procedures
The following sections describe some common HP SSA CLI procedures.
Setting the boot controller
This procedure is only available in the offline environment.
The boot controller is the first controller that the system examines (after power up) to find a bootable logical
drive or volume. To work properly, the boot controller must have a designated boot volume. See "Setting the
boot volume (on page 53 )."
Syntax:
<target> modify [bootcontroller=enable|disable]