HP Smart Storage Administrator - Manual (Page 96)

Operations 96
Error code Error message Comment or clarification
drive ID specified in the script file already exists in
the configuration. In Configure mode, you can
create new logical drives only.
2838 Cannot create Logical Drive The array has no free space, or the maximum
number of logical drives has been reached already.
2839 Cannot migrate Logical Drive RAID The controller does not support RAID migration, or
migration is not possible with the current controller
configuration.
2841 Cannot extend Logical Drive The controller does not support extension, or the
current controller configuration cannot be extended.
For example, extension is not possible if the array
has no free space.
2842 Invalid RAID The specified RAID level is invalid or is not possible
with the current physical disk and array
configuration.
2843
Invalid Size The specified size is invalid or is not possible with the
current configuration.
2844 Invalid Stripe Size The specified stripe size is invalid, not supported by
the current RAID level, or not possible with the
current configuration.
2849 Invalid ClearConfigurationWithDataLoss
parameter
The valid parameters are Yes and No (default).
2850 Controller does not support Chassis Name The controller does not support setting a chassis
name.
2851 Invalid Chassis Name The entered chassis name is invalid. Use characters
from the set a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +,
:, ., /, and [space]. The name cannot end with a
space character or exceed the maximum number of
characters allowed by the controller.
2852 Invalid SSP State The requested SSP state is not a valid SSP state.
2853 Cannot change SSP settings The SSP settings cannot be changed for the controller
or logical drive.
2854 Invalid SSP Adapter ID The adapter ID is not a valid adapter ID that was
detected by the controller.
2857 Invalid Surface Scan Delay —
2861 Controller does not support redundancy
settings The controller is not redundant or does not support
redundancy settings.
2864 Invalid Preferred Path Mode The specified value for the preferred path mode is
not valid, or the controller is not available.
2865 Invalid Preferred Path The specified preferred path is not a valid chassis
slot for an available, active controller, or the
controller is not available.
2866 Failure opening capture file —
2867 Failure opening input file —
2868 Failure opening error file —
2877 There are no suitable spares available HP SSA found no drives that could be used as spares
for the specified array.