HP LaserJet 4000 Printer series - Manual (Page 149)

B-14 Control Panel Menus
EN
/12+'4/1&'
56#0&#4&
56#0&#4&
'0*#0%'&
1((
Determine how the mopier functions behave.
This item appears only when there is at least
8 MB of memory or an optional hard disk is
installed.
56#0&#4&
: This option is available if there is
either a hard disk installed or a RAM disk
configured in memory. This option uses I/O
data stored in printer memory for generating
multiple original prints. (All copies will print at
the same speed as the first copy.)
'0*#0%'&
: This option is available if there is a
hard disk installed and at least 8 MB of memory.
This option uses engine video data for printing
multiple original prints and should print all
copies after the first at the printer’s maximum
speed.
1((
: Disables the mopier functions. (The
printer will not spool any jobs to the hard disk.)
When the mopier mode is changed, any
downloaded resources (such as fonts or
macros) will need to be downloaded again,
unless they are stored on an optional hard disk
or flash DIMM.
4#/&+5- 1(( 1((
10
#761
Determine how the RAM disk is configured.
This item appears only if there is no optional
hard disk installed and the printer has at least
8 MB of memory.
1((
: The RAM disk is disabled.
10
: The RAM disk is enabled. Configure the
amount of memory to be used through the
following item:
4#/&+5-5+<'
.
Note
If the setting is changed from
1((
to
10
or from
1((
to
#761
, the printer will automatically
reinitialize when it becomes idle.
4#/&+5-5+<'
ZZZ-
-
and up
(This value
depends on the
amount of
installed
memory.)
Determine the size of the RAM disk. This item
appears if
4#/&+5-
=
10
or
#761
.
Press [-Value+] to change settings by
increments of 100.
Note
This setting cannot be changed if
4#/&+5-
#761
. Changing this value will cause the
printer to reinitialize when it becomes idle.
Configuration Menu (Continued)
Item Values Explanation