HP LaserJet 4000 Printer series - Manual (Page 89)

78 Chapter 4: Problem Solving
EN
2#4#..'.+1
$7(('418'4(.19
alternates with
24'55)161
%106+07'
Too much data was sent to the parallel port.
Check for a loose cable connection and be sure to use a high-quality
cable. (Some non-HP parallel cables might be missing pin
connections, or might otherwise not conform to the IEEE-1284
specification.)
This error can occur if the driver you are using is not IEEE-1284
compliant. For best results, use an HP driver that came with the
printer.
Press [Go] to clear the error message. (Data will be lost.)
If this message persists, contact an HP-authorized service or support
provider. (See the HP Support pages at the front of this user’s guide.)
5'4+#.+1
$7(('418'4(.19
alternates with
24'55)161
%106+07'
Too much data was sent to the serial port.
Make sure the correct serial pacing option is selected from the I/O
Menu in the printer’s control panel.
Print a menu map and verify that the serial pacing item (from the I/O
Menu in the printer’s control panel) matches the setting on the
computer. Press
[Go] to clear the error message. (Data will be lost.)
If this message persists, contact an HP-authorized service or support
provider. (See the HP Support pages at the front of this user’s guide.)
$#&5'4+#.
64#05/+55+10
alternates with
24'55)161
%106+07'
The printer encountered an error while transferring data from the
computer.
The error might have occurred for several reasons:
• The computer was powered on or off while the printer was online.
• There was a network problem (if applicable).
• The printer’s baud rate or parity was not the same as the
computer’s. (The baud rate tells the printer how fast information will
be transferred from the computer to the printer.) Make sure the
printer is set for the same baud rate as the computer. The serial
baud rate setting can be accessed from the I/O Menu in the printer’s
control panel.
Press [Go] to clear the error message and continue printing.
'+1Z$#&
64#05/+55+10
alternates with
24'55)161
%106+07'
The connection has been broken between the printer and the EIO
card in the specified slot.
Press [Go] to clear the error message and continue printing.
Printer Messages (Continued)
Message Explanation or Recommended Action