HP LaserJet 4000 Printer series - Manual (Page 40)

EN
Chapter 2: Printing Tasks 29
Loading the Optional 500-Sheet Tray
The optional 500-sheet tray is Tray 3 for
the HP LaserJet 4000/4000 N printers,
or Tray 4 for the HP LaserJet 4000 T/
4000 TN printers. This tray is adjusted
differently than Tray 2 (page 27). Tray 2
and the optional 500-sheet tray can be
interchanged in the printer. For
supported sizes of paper, see
page A-4.
Note
To avoid paper jams, do not load trays
while the printer is printing.
1 Pull the tray completely out of the
printer.
2 If the tray is not already set to the
desired paper size, squeeze the
release on the left guide and adjust
the left and right guides to match the
width of the paper.
3 Squeeze the release on the back of
the rear paper guide and slide it to
the desired paper size.
4 Load the tray. For correct
orientation, see page 36.
5 Make sure the paper is flat in the tray
at all four corners and below the tabs
on the guides. The guides should
touch the paper without bending it.
Continued on the next page.