HP LaserJet 4000 Printer series - Manual (Page 151)

B-16 Control Panel Menus
EN
I/O Menu
Items in the I/O (input/output) Menu affect the communication
between the printer and the computer.
I/O Menu
Item Values Explanation
+16+/'176  
to

Select the I/O timeout period in seconds. (I/O
timeout refers to the time, measured in
seconds, that the printer waits before ending a
print job.)
This setting allows you to adjust timeout for
best performance. If data from other ports
appear in the middle of your print job, increase
the timeout value.
Press [- Value +] once to change settings by
increments of 1, or hold down [- Value +] to
scroll by increments of 10.
+1$7(('4 #761 #761
10
1((
Allocate memory for I/O buffering.
#761
: The printer automatically reserves
memory for I/O buffering. Additional
configurations are not required and the
+1 $7(('45+<'
menu item does not
appear.
10
: The
+1$7(('45+<'
item appears (see
below). Specify the amount of memory to be
used for I/O buffering.
1((
: I/O buffering is not performed and the
+1 $7(('45+<'
item does not appear.
When the I/O buffer setting is changed, any
downloaded resources (such as fonts or
macros) will need to be downloaded again,
unless they are stored on an optional hard disk
or flash DIMM.
For more information, see page C-6.
+1$7(('45+<'
-
-
and up This item appears only when
+1$7(('4
10
. Specify the amount of memory for I/O
buffering. The maximum amount of memory
available for I/O buffering is determined by the
amount of memory installed in the printer, the
languages installed in the printer, and by other
memory allocations that must be made.
Press [-Value +] to change settings by
increments of 10 (up to 100 KB) or by
increments of 100 (above 100 KB).