Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 129)

PF3000 Pro Direct Drive – Mark III/Mark IV
Ag Leader Technology Application Rate Mode
July 2003 2-115
Set to USE LAST if want rate to be the last rate used at the time
the vehicle is detected outside the field. This is useful when
experiencing problems with the vehicle being falsely detected
outside of the field during the outside pass of the field.
Set to TGT DEFAULT if want rate outside field to be the default
rate stored in the target rate file.
Controller Time Delay: Set to 2 seconds.
Actual Rate Units: Set to Units/ac of application.
Log Actual Rate: Set to YES to log actual rate to card. Set to
NO to not log actual rate to card.
A configuration of settings must be created for each product
applied. For example, create one for Lime, another for DAP and
another for Potash. Repeat steps 1-3 to create a new
configuration. Product Density, Swath and Feed Gate Opening
and other settings are stored separately for each configuration.
4. Exit back to main screen.
a) Press FIELD key twice.
b) Select appropriate field and press VIEW CONFIG key.
c) Select appropriate product/controller configuration and press
ACTIVE ON/OFF key to check it as active.(All other configs
must be unchecked first).
d) If you will be using a target file, press EDIT TGT FILE key,
otherwise press EXIT key and skip to step f.
e) Select target file. Press VIEW INFO key to ensure it is the
correct one. After exiting the view info screen, press
ACCEPT key. Press EXIT key.
f) Press ACCEPT key to accept field.