Innovate Motorsports SCG-1 User Manual

Page 13

Advertising
background image

13

defined lean A/F that will trigger the safety cut. When the Boost
Cut by AFR
is triggered, the SCG-1 will display “O2 Cut” on the
upper right hand corner. Default setting is a start pressure of 4.9
PSI and 13 AFR.
Tuning Tip: Set the Start Pressure at the same pressure value as
Spring Pressure.

6. Boost Control ON/OFF – When configured from the gauge, this

setting is accessed from the main screen. Press and HOLD both the
left and right interface buttons, this will disable/enable solenoid
control. If there are no other error codes on the status viewport of
the screen, the SCG-1 will display “SC OFF”. In LM Programmer,
use the Boost Control ON checkbox to turn the solenoid control
ON/OFF. Default setting is ON.

4

Logworks 3 & LM Programmer Software Package


The SCG-1 can be connected directly to your Windows computer to log and
analyze data with the Logworks software or to configure with LM
Programmer. The software is a free download on the Innovate Motorsports’
support section of the website.

4.1

Download and Install the Logworks 3 Software

1. Open your web browser and go to the following URL:

http://www.innovatemotorsports.com/support.php

2. The LogWorks 3 software download will be the very first thing on the

page under the heading Software, click the link to download the
software.

3. Double click on the Logworks 3 installer previously downloaded from the

support section of the Innovate Motorsports web site.

Advertising