Innovate Motorsports SCG-1 - Manual (Page 14)

14
4. The installer will start, follow the prompts to install the software.
5. Once the software has been installed, the LogWorks software, LM
Programmer, manuals, and tools can then be located by navigating
through Start->Programs->LogWorks3.
4.2 LM Programmer
LM Programmer is used to configure settings on your SCG-1.
1. Connect the OUT port of the SCG-1 to the provided serial
programming cable. Connect the other end of the serial
programming cable to your computer. If your computer does not
have a serial port, you can purchase a USB to Serial adapter from
Innovate Motorsports (P/N 3733) or use any USB to serial adaptor
that includes drivers. Make sure that nothing is connected to the IN
port of the SCG-1
2. Power up the SCG-1.
3. Launch LM Programmer. The LM Programmer application can be
launched from Start->Programs->LogWorks3->LM Programmer from
the Windows task bar.
4.2.1 Programming Analog Output
Connect the SCG-1 to the computer and launch LM Programmer. Select the
Analog Output tab. The analog output configuration screen shows voltage
versus Lambda for the analog output. The graph display is automatically
scaled to the selected voltages values. The configuration screen allows the
user to specify a minimum and maximum lambda or A/F value to a
corresponding voltage range.