Innovate Motorsports SCG-1 User Manual
Page 6
6
2.2
Gauge Mounting and Routing
The SCG-1 gauge fits in any standard 2 1/16” (52mm) gauge pod. Mounting
of the gauge should be done in such a manner that the cables are not being
forcefully pulled and strained from the gauge itself. Route the sensor and
solenoid cables avoiding contact with the exhaust system and other vehicle
components that could damage the cable. Also avoid routing the cables near
ignition components or other sources of RF (radio frequency) and EMI
(Electromagnetic interference) noise.
2.3
Solenoid Installation
-
Mount the solenoid in a suitable location away from high
temperatures or near ignition components.
-
Secure hoses with cable ties.
-
Make sure not twist or pinch any of the hoses.
-
The solenoid will make audible clicking noises when in operation,
this is normal.
-
Route the solenoid cable through the firewall, to the gauge and
connect to the 2 pin connector.
-
Confirm that you do not have any air leaks when the engine idles.
2.3.1 Internal
Wastegate