Innovate Motorsports SCG-1 - Manual (Page 18)

18
MERCHANTABILITY, NONINFRINGEMENT, AND FITNESS FOR A PARTICULAR PURPOSE,
AND THE LIABILITY OF INNOVATE, IF ANY, FOR DAMAGES RELATING TO ANY
ALLEGEDLY DEFECTIVE PRODUCT SHALL UNDER ANY TORT, CONTRACT, OR OTHER
LEGAL THEORY BE LIMITED TO THE ACTUAL PRICE PAID FOR SUCH PRODUCT AND
SHALL IN NO EVENT INCLUDE INCIDENTAL, CONSEQUENTIAL, SPECIAL, OR INDIRECT
DAMAGES OF ANY KIND EVEN IF INNOVATE IS AWARE OF THE POSSIBILITY OF SUCH
DAMAGES. Some states do not allow limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or consequential damages, so the above limitations or
exclusions may not apply to you.
Appendix B: SCG-1 Error Codes and Troubleshooting Tips
Error
Code Error
Message Likely Root Cause Fix
Error 1 Heater circuit
shorted Short in sensor Replace sensor.
Error 2 Heater circuit
open 1. Damaged sensor
cable or sensor.
2. Sensor connector not
fully seated and locked
into position. 1. Verify that all sensor
connectors are fully seated and
locked into position.
2. Replace sensor
3. Replace sensor cable.
Error 3 Pump cell
circuit shorted 1. Short in sensor
cable
2. Short in sensor
3. Sensor calibration
incorrect 1. Replace sensor cable.
2. Replace sensor.
3. Perform sensor recalibration.
Error 4 Pump cell
circuit open 1. Damaged sensor
cable or sensor.
2. Connectors not fully
seated
3. Sensor calibration
incorrect 1. Verify that all sensor
connectors are fully seated and
locked into position.
2. Perform sensor calibration
3. Replace sensor cable.
4. Replace sensor.
Error 5 Reference cell
circuit shorted 1. Short in sensor
cable
2. Short in sensor 1. Replace sensor cable.
2. Replace sensor.
Error 6 Reference cell
circuit open 1. Damaged sensor
cable or sensor.
2. Connectors not fully
seated 1. Verify that all sensor
connectors are fully seated and
locked into position.
2. Replace sensor.
3. Replace sensor cable.
Error 7 System error System error Reboot SCG-1 by cycling
power.
Error 8 Sensor
Timing error
(typically a
damaged
sensor). 1. Sensor over-heating
or over-cooling (error
condition only occurs
at wide open throttle )
2. Sensor is damaged 1. Perform sensor calibration.
2. Move sensor bung as far
downstream as possible.
3. Add an HBX-1 (p/n 3729) to
isolate the sensor from the
pipe.