Innovate Motorsports SCG-1 - Manual (Page 3)

3
3. Interface Buttons
- Pressing either the left or right interface buttons will allow you to
cycle through the 4 different display modes.
- From the main screen, pressing and HOLDING the left interface
button will put the gauge in setup mode. Once in setup mode,
pressing and HOLDING both interface buttons together will move
you to the menu or main screen. The gauge will revert back to the
main screen if no there have been no button presses for 15 seconds.
- From the main screen, pressing and HOLDING both the left and right
interface buttons will disable/enable solenoid control. If there are no
other error codes on the status viewport of the screen, the SCG-1
will display “SC OFF”.
4. Shift Light
- Illuminates when the trigger shift RPM is reached.
1.1 Changing the SCG-1’s gauge face and/or bezel
1. Lay the SCG-1 face down and remove the three #2 phillips screws
from the outside rim of the back plate.
2.