Nitrous Express DRAG-Pro N2O - Manual (Page 16)

15
Davis Technologies TM-4000-Drag-PRO V3 n
2
0 2010
Configuring
Trigger Count:
(default= 8)
The unit must be configured for the number of
counts it will receive per revolution of the driveline.
Once set the value will remain until changed by the
user. To change the value, follow these steps.
1. Set the “Mode” dial to “4”
2. Hold down the “Test” button
3. Turn the power On
4. While holding the “Test” button down, move
the dial to the desired number of triggers divided by
two.
(example- 8 triggers/2=4)
5. Release the “Test” button.
The LED will flash to show the number of triggers
the unit is now set to.
(The Trigger Count must be set
correctly for the accurate RPM calculations)
Starting RPM:
(default (15 ) 1500 Rpm)
The driveline RPM at which the unit Starts to make
corrections can be set by the user. Once set the
value will remain until changed by the user. The
RPM is set in 100 rpm increments, (example 1500
rpm, divided by 100 = 15). To change the Starting
RPM value, follow these steps.
1. Set the “Mode” dial to “3”