Nitrous Express DRAG-Pro N2O - Manual (Page 24)

23
Davis Technologies TM-4000-Drag-PRO V3 n
2
0 2010
The Advanced values can be verified at any time by
following these steps.
1. Turn the power “On”
2. Set “Mode” dial to “OFF”.
3. Press the “Test” button and HOLD
DOWN.
4. First, the value of the Starting RPM is
shown. The LED will blink for the first digit
followed by a short pause, then the LED will
blink for the second digit. (1500 RPM = 1,5
Blinks) (zeros are indicated by shorter
blinks).
5. After a pause, The value for the Ending
RPM is shown. The LED will blink for the
first digit followed by a short pause, then
the LED will blink for the second digit. (8500
RPM = 8,5 Blinks) (zeros are indicated
by shorter blinks).
6. After a short pause, the LED will flash for the
value of Trigger Count.
(8 Triggers=8 Blinks).