Nitrous Express Octane Series Progressive - Manual (Page 14)

SCROLL DOWN:
This is the start of your RPM window where the gauge will start the nitrous activation. (if all other
conditions are met). Pushing the control button in will turn the area grey and you can scroll up or
down to the correct value. Push the control button in again to save.
SCROLL DOWN:
This is the end of your RPM window, above which the gauge will stop the nitrous activation. Pushing
the control button in will turn the area grey and you can scroll up or down to the correct value. Push
the control button in again to save.
SCROLL DOWN:
This is the solenoid frequency. It sets is how many times/second your solenoids will be pulsed. 15Hz
is a good number to start with. Small solenoids may be able to handle a higher setting. When in
doubt, consult the solenoid manufacturer. Pushing the control button in will turn the area grey and
you can scroll up or down to the correct value. Push the control button in again to save.
SCROLL DOWN:
This sets how the nitrous ramp is set [N2O vs.TIME or N2O vs. RPM] You can toggle the setting by
pushing the control button while it is highlighted.
SCROLL DOWN:
This is the end point of the RPM based nitrous ramp [RPM based mode only].
THIS IS NOT WHEN
THE NITROUS TURNS OFF it just allows you expand the resolution of the ramp. The system will
continue to pulse the solenoids until Rpm Max is reached, using the rate set at the end of the user
configured ramp.
Pushing the control button in will turn the area grey and you can scroll up or down
to the correct value. Push the control button in again to save.
SCROLL DOWN:
This is how much time the nitrous will be delayed by once all conditions for activation are met. IF you
have FGD set to Y, and you exceed Rpm Max, the delay will be ignored until you either reset the
gauge or re-arm it. This allows you to set a delay that is only active in first gear. Pushing the control
button in will turn the area grey and you can scroll up or down to the correct value. Push the control
button in again to save.
SCROLL DOWN:
This is the time the ramp takes to reach its final setting, also referred to as build time. Pushing the
control button in will turn the area grey and you can scroll up or down to the correct value. Push the
control button in again to save.