Alpine IVA-D300 - Manual (Page 26)

24
-EN
Switching Display Modes
After carrying out the steps 1 to 3 of “To display the DVD mode
Screen” explained on page 27, perform the operation described below.
While your vehicle is parked, touch [WIDE] on the
visual source screen.
Each touch changes the display modes as follows:
MODE 1 → MODE 2 → MODE 3 → MODE 4 → MODE 1
(WIDE) (ZOOM) (CINEMA) (NORMAL) (WIDE)
In Mode 1 (Wide), the monitor displays a normal picture wider
to fit in a wide-screen monitor by evenly stretching out the
picture horizontally.
In the Mode 2 (Zoom), the monitor displays a normal picture
wider to fit in the wide-screen monitor by unevenly stretching
out. The centre portion of the picture is stretched out only
slightly in order to make the important centre portion of the
picture look natural.
In Mode 3 (Cinema), the monitor displays a normal picture by
stretching out the picture horizontally and vertically. This mode
is good for displaying a cinema type picture at the 16 : 9 ratio.
In Mode 4 (Normal), the monitor displays a normal picture at
the center of the screen with a vertical black band at each
side.
MODE4
MODE3
MODE1
Switching the function of the remote sensor
For optional remote control operation, the remote sensor of the
external device (monitor, etc.) can be switched, as you prefer.
4
Touch [FRONT], [REAR 1] or [REAR 2].
The monitor which has a priority to the remote control
operation is changed.
FRONT: The remote sensor of this unit is effective.
REAR1: The remote sensor of the external monitor
connected to AUX OUT of the tuner box of this
unit, or the optional expansion box (VPE-S431)
is effective, and the remote control can operate
only the source selected for the terminals.
REAR2: The remote sensor of the external monitor
connected to AUX OUT of the optional
expansion box (VPE-S431) is effective, and the
remote control can operate only the source
selected for the terminals.
• When you watch the built-in DVD in IVA-D300 (front monitor) and
in the rear monitor, the On Screen display of the rear monitor
(PLAY, PAUSE, FAST FWD, etc.) is not displayed.
• The sensor of the touch panel rear monitor has priority over the
sensor of the remote control, if the rear monitor (connected to the
Alpine touch panel rear monitor via the Monitor control lead) is
touched, regardless of the remote control sensor switch setting.
Note, however, that the sensor of the remote control that has been
set takes priority if it has been 5 seconds since last touching the
panel.
• When an optional DVD changer or DVD player is connected, and
the remote control sensor is set to REAR1 or REAR2, some touch
button operations ( [L] STOP, etc.) cannot be performed.
In this case, set the remote control sensor to FRONT.
MODE2