Alpine IVA-D300 - Manual (Page 69)

67
-EN
Installation
Installing the Monitor
Installation Location
Before deciding on the mounting location, check that opening and
closing the display will not hamper gear shifting in that position.
• Install at an angle of within 30 degrees from the horizontal.
• The monitor's angle is set to 90 degrees at the factory. Depending
on the car, the monitor may hit the dashboard when opened. The
monitor's angle can be adjusted and stored in memory so that the
monitor will not hit the dashboard when opening. For adjusting the
monitor, refer to "Adjusting the monitor Angle" on page 26.
Even when the vehicle's battery power is removed, the adjusted
monitor angle remains stored in memory.
1
Slide the mounting sleeve into the dashboard. Install the
supplied bracket on the monitor.
• Make sure to use the supplied screw (M4 × 3) to install the monitor.
If you use another screw to install the monitor, it may cause a
malfunction.
2
Lock Pin
Reinforce the monitor unit with a metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean
metal spot using a screw (}) already attached to the
vehicle's chassis.
• For the screw marked }}, use an appropriate screw for the
chosen mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from
the left rear of the IVA-D300. Connect all other leads of the
IVA-D300 according to details described in the
Connections section.
3
Slide the IVA-D300 into the dashboard. When the unit is in
place, make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in on
the unit while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly locked
and will not accidentally come out from the dashboard.
Install the supplied Front Frame.
Removal
1. Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see Step 3). As each
pin is unlocked, gently pull out on the unit to make sure
it does not re-lock before unlocking the second pin.
2. Pull the unit out, keeping it unlocked as you do so.
< JAPANESE CAR >
To install using the vehicle's standard bracket.
• Make sure to use the supplied screw (M4
× 6) to install the monitor.
If you use another screw to install the monitor, it may cause a
malfunction.
IVA-D300
Screws (M4 × 6)
(Included)
Mounting Bracket
Ground Lead
IVA-D300
Front Frame
(Included)
Bolt Stud
Metal Mounting
Strap
Screw
Hex Nut (M5)
Ground
Lead
Chassis
Wider edge should face down.
Screws (M4 × 3)
(Included)
Mounting Bracket
(Included)
Dashboard
Mounting Sleeve
(Included)
IVA-D300