Alpine IVA-D300 - Manual (Page 53)

51
-EN
Navigation System (Optional)
Switching the Navigation Screen (Optional)
If an optional Alpine Navigation System is connected to the IVA-
D300, the Navigation screen can be displayed on this unit.
1
Touch [SRC] on the main source screen.
The source screen appears on the display.
2
Touch [NAV].
The Navigation screen is displayed.
The operation is possible with the supplied navigation
remote control.
For navigation operation, refer to the Owner's Manual of
the navigator.
• When V. SEL is pressed while the Navigation selection mode is
being selected in “Setting Visual Mode” (page 33), the navigation
mode will be directly activated.
• If the Navigation mode menu is not displayed on the main menu
screen, set NAV. IN to on by following "Setting the navigation
Mode" (page 32).
• When the Navigation System is on, the audio and visual navigation
cuts in.
Auxiliary Device (Optional)
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX terminals on the rear
panel of IVA-D300, follow the procedure described below.
WARNING
It is dangerous (and illegal in many states) for the driver to
watch the TV/Video while driving the vehicle. The driver
may be distracted from looking ahead and an accident
could occur.
Install the IVA-D300 correctly so that the driver cannot
watch TV/Video unless the vehicle is stopped and the
emergency brake is applied.
If the IVA-D300 is not installed correctly, the driver will be
able to watch the TV/Video while driving the vehicle and
may be distracted from looking ahead and cause an
accident. The driver or other people could be severely
injured.
To activate your auxiliary devices:
To watch a video source, your vehicle must be parked with
the ignition key in the ACC or ON position. To do this, follow
the procedure below.
1. Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2. Keep pushing the foot brake and release the parking
brake once then engage it again.
3. When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission
lever in the Park position.
Now, the locking system for the AUX mode operation has
been released. Engaging the parking brake can reactivate
the AUX mode, as long as the car's ignition has not been
turned off. It is not necessary to repeat the above
procedure (1 through 3), of “To activate your auxiliary
devices.”
Each time the ignition is turned OFF, perform the procedure
of “To activate your auxiliary devices.”
• If you try to activate the auxiliary device while driving, the
display will show the warning-PICTURE OFF FOR YOUR
SAFETY.
1
Touch [SRC] on the main source screen.
The source screen appears on the display.
2
Touch [AUX]*.
The external input screen is displayed.
* AUX-1 to AUX-3 are displayed if the external input devices
(maximal 3) are connected, or the name which is given as the
source name in “Naming External Devices” on page 33 is
displayed.
• If the AUX mode is not displayed on the main menu, set AUX IN to
ON by following "Setting the AUX Mode" (page 33).
• The display mode changes by touching [WIDE].
For operation, refer to “Switching Display Modes” on page 24.