Alpine IVA-D300 - Manual (Page 45)

43
-EN
Recalling the Stored Contents of Amplifier
Adjustment
1 Select P-1 or P-2 by touching [;] or [:] of MEMORY
READ from the adjustment mode list.
2 Touch [READ].
Stored adjustment data will be recalled.
Titling the Amplifier
1
From the AMPLIFIER LINK list screen, touch [ ]
of an amplifier to which a title is to be given.
The adjustment mode list screen appears.
2
Touch [ ] of NAME.
The title input screen appears.
3
Touch the desired character symbols.
You can use up to 8 characters.
4
After the input, touch [ENT] to confirm your entry.
As the entry is confirmed, the screen immediately before
the current one will be restored, and the title that has been
entered from the AMPLIFIER LINK list screen is shown.
Displaying Status of External Amplifier
You can display the status of the connected external amplifier (MRD-
M301 or MRD-M501) for AMP Link.
1
Touch [V.SEL] on the main source screen.
The VISUAL selection screen appears.
2
Touch [AMP STATUS].
The AMP status screen appears.
Display Example for AMP status screen
1 Amplifier Name
2 Turns pages
3 Temperature (°F)
4 Voltage (V)
5 Electric Currency
3
To cancel the AMP status screen, touch [V.SEL].
The VISUAL selection screen is displayed.
4
Touch [NORMAL].
The screen returns to the normal screen.
External Audio Processor
(Optional)
When an external audio processor is connected to this unit, you can
operate it from this unit. Some audio processors may not be operated.
When PXA-H510 or PXA-H900 is connected, some of the operations
may not be performed from this unit. In this case, operate them in the
connected product. Explanations below is the case when PXA-H700
or PXA-H701 is connected for example.
Refer also to the operating instructions of the connected audio
processor.
• The adjustments or settings performed on the connected audio
processor cannot be operated properly from this unit.
To display the Audio processor mode screen:
To watch a video source, your vehicle must be parked with
the ignition key in the ACC or ON position. To do this, follow
the procedure below.
1. Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2. Keep pushing the foot brake and release the parking
brake once then engage it again.
3. When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission
lever in the Park position.
Now, the locking system for the Audio processor mode
operation has been released. Engaging the parking brake
can reactivate the Audio processor mode, as long as the
car's ignition has not been turned off. It is not necessary to
repeat the above procedure (1 through 3), of “To display
the Audio processor mode screen.”
Each time the ignition is turned OFF, perform the procedure
of “To display the Audio processor mode screen.”
Continued 1
2
3
4
5
2