GReddy TURBO KITS: Honda S2000 (AP2) 2004-06 / T518Z - Manual (Page 28)

3-17 e-Manage Ultimate Installation
(1) Remove the driver side kick panel cover in order to access the ECU and ECU harness.
(2) Disconnect the ECU harness from the ECU.
(3) Connect the Emanage Ultimate Plug and Play Harness to the ECU and plug the stock ECU harness
into the Ultimate Plug and Play Harness.
(Parts used: 14, 15)
(4) Keep the Emanage Ultimate unit in a cool, dry place. Try not to cover it with any carpeting, and keep it
out of direct sunlight.
3-18 Starting the Engine
(1) Refill the engine oil to factory spec.
(2) Check all the hoses and wires connection and reconnect the negative side of the battery.
(3) Turn the ignition to “ON” position 2-3 times to get fuel pressure. Then, check the injectors and the fuel
rail for any fuel leaks.
* Repair any fuel leaks before starting the engine. Starting the engine with a fuel leak can cause
fire in the engine compartment and can be very dangerous.
(4) Remove the ECM fuse and crank the engine to get oil pressure to the turbo. (Until the oil light on the
dash turns off) Check for any oil leaks, then reinstall the fuse and start the engine.
(5) While idling, check for any oil, coolant, or air leaks.
(6) After inspection, reinstall the under cover and other stock parts that was removed.
(7) On the initial run, be sure to have a boost gauge to check the turbo-actuator setting. This turbo kit is preset
to boost between 0.50kg/cm 2 to 0.55kg/cm 2 ( 7 – 8 PSI ).
It is very important that you monitor the boost pressure, and make sure not to over boost. Over boosting can
cause engine damage.
This completes the Turbo Kit installation.