Kenwood TK-5210G/5310G - Manual (Page 16)

8
Optional
antenna
I
NSTALLING THE
(O
PTIONAL
) A
NTENNA
Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and turning
it clockwise until secure.
I
NSTALLING THE
B
ELT
C
LIP
If necessary, attach the belt clip
using the two supplied 3 x 8 mm
binding screws.
Note: If the belt clip is not
installed, its mounting location may
get hot during continuous
transmission or when left sitting in
a hot environment.
Binding screws
Belt clip
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver.
Acrylic ester, which is contained in these glues, may crack the
transceiver’s back panel.