K3 m – Kenwood TK-5210G/5310G User Manual
Page 42
![background image](/manuals/410822/42/background.png)
34
S
ELECTING
THE
E
NCRYPTION
K
EY
1
Press the key programmed as Scrambler/ Encryption
Code (K2 and K3 Models Only) or press and hold the key
programmed as Scrambler/ Encryption for 1 second, to
enter Key Selection Mode.
2
Select the new Encryption key using the Side 2 and Side
3 keys or the <C and D> keys.
•
There are 16 available Encryption keys (1 ~ 16).
•
Each group member must select a key that is in each
member’s key list in order for the transceivers to descramble
the received signals.
3
Press the Side 1 key to set the new Encryption key.
Note: To return the transceiver to the default Encryption key
programmed, select “PRESET”. However, if you delete the
Encryption key (see below), it will not be recovered.
D
ELETING
THE
E
NCRYPTION
K
EY
(K2
AND
K3 M
ODELS
O
NLY
)
1
Press the key programmed as Key Delete to enter Key
Delete mode.
2
Select the current Encryption key using the Side 2 and
Side 3 keys or the <C and D> keys.
3
Press the B key to delete the Encryption key.
4
Press the Side 1 key to exit Key Delete mode.
Note: To delete all Encryption keys (when more than one key has
been set up), select “ALL”.
P
ASSWORD
P
ROTECTION
(K2
AND
K3 M
ODELS
O
NLY
)
If the transceiver is password protected, entering an incorrect
password successively 15 times will automatically delete all
the Encryption keys.
•
Turning the transceiver power OFF and the ON again will not
reset the number of attempts for entering an incorrect password.