Kenwood TK-5210G/5310G - Manual (Page 33)

25
S
CAN
P
ROGRAMMING
(K2
AND
K3 M
ODELS
O
NLY
)
Using the key programmed with Scan Program, you are able
to reprogram your scan list.
1
Press the key programmed as Scan Program.
• The icon appears on the display and blinks.
2 Press the Side 2 and Side 3 keys to select the zone or
channel you will add to or remove from the scan list.
• The icon appears on the display for zones/ channels that
are added to the scan list.
• Press the A key to toggle between Zone Select and Channel
Select.
3 Press the <C key to add the selected zone or channel to
the scan list or the B key to remove the selected zone or
channel from the scan list.
• The icon appears on the display when a zone/ channel is
added to the scan list, and disappears when a zone/ channel
is removed from the scan list.
If the Priority channel has been set as Operator Selectable by
your dealer, you are able to reprogram the Priority mode as
well.
1
Press the key programmed as Scan Program.
• The icon appears on the display and blinks.
2 Press the Side 2 and Side 3 keys to select the channel
you will set as the Priority channel.
3 Press the A key.
4 Press the D> key to toggle the selected channel between
Priority mode and Normal mode.
• “P1”, “P2”, or “PP” appears on the display when Priority mode
is selected.
5 Press the A key again to set the new channel setting.