MagTek InSpec 9000-2005 - Manual (Page 13)

3
SECTION 2. INSTALLATION
This section provides instructions for installing the Tester. There are five parts to the installation
of the InSpec 9000-2005 Tester: unpacking, hardware installation, software installation, setup,
and cleaning. Because card sampling is required for production, some examples are referenced in
this section.
UNPACKING
Remove all material from the shipping carton and check the material with the shipping invoice
to ensure everything on the invoice is contained in the carton. If there is damage to the unit or
material on the invoice is missing, notify MagTek and the carrier.
Note
Retain the shipping carton and all packing material. The Tester
may be packed and shipped back to the factory periodically for
calibration or warranty service .
HARDWARE
Install the hardware as follows:
1.
Place the Tester near the PC and a wall receptacle so that the cables can be installed.
Caution
Ensure power is off before plugging in cables, or
damage to equipment or the program may result.
2. For RS-232 plug the cable with the 9-pin connector into the Tester and the other end to
the PC Com Port. It may be necessary to use a DB9 to DB25 adapter for the Com port.
3.
Plug the power cord into the Tester and the wall receptacle.
4.
Power up the computer and press the power on (I) switch on the rear panel of the Tester.
5.
The LED on the front of the Tester should be green. If the LED does not come on, check
to ensure the cables are properly connected.
6.
If the LED still does not light, press the power switch off, remove the cables, and check
the fuse, located next to the power switch as shown in Figure 2-1.