MagTek InSpec 9000-2005 - Manual (Page 14)

InSpec 9000-2005 Encoded Card Tester
4
Figure 2-1. Fuse Holder
7. Replace the fuse if necessary, reconnect the cables, and power up. If the LED still does
not light, call for technical or supervisory personnel.
SOFTWARE
Installation
1 Install MCP software. Insert the MCP CD into your CD drive. The setup
program should start automaticly. Keep the default selection for all
options during the installation.
2 Allow the setup program to restart the PC
3 Allow the setup program to finish after startup. This should be very
brief.
4 Plug in the Intellistripe 380 to any USB port of the PC. Ensure the the
Intellistripe 380 has power.
5 Allow the PC toinstall the new hardware. The ‘Found New Hardware’
message should appear in the lower right corner of the screen.
6 Instal Inspec 9000-2005 software. The setup program should start
automaticly.
InSpec 9000-2005 (all users)
To begin the installation, insert the InSpec 9000-2005 CD into the appropriate drive. The
installation program will automatically start. If the installation program does not start
automatically, select Run from the Start menu. Within the open field, type x:\demo32, where x:
is the drive letter of your CD ROM drive. Click OK to begin the installation. The installation
program will guide you through the setup process.