MagTek InSpec 9000-2005 - Manual (Page 52)

InSpec 9000-2005 Encoded Card Tester
42
CARD EXTRACTION
The card extraction tool (CET) is a slim rod with a handle on one end and a hook on the other.
The handle and the hook are oriented in the same plane.
Remove the card as follows:
1.
Perform the other “Card does not eject” procedures in the Troubleshooting Table before
using the extraction tool.
Caution
Ensure power is off before inserting the tool or the unit may become damaged.
2.
Press the power switch off (O).
3.
Orient the Card Extraction Tool so the hook and handle are in a parallel plane with the
card as indicated in Figure 5-1.
Figure 5-1. CET Orientation
4.
Insert the tool up to the handle as shown in Figure 5-2.
Figure 5-2. CET Insertion