MagTek InSpec 9000-2005 - Manual (Page 4)

iv
SAFETY
afety Certification Agencies, compliance
ith all Installation Instructions and Safety Requirements is essential.
SAFETY REQUIREMENTS
ever do any of the following:
nd adapter plug to connect equipment to a power source receptacle that lacks a ground connection
terminal.
nction that is not specifically described in this Manual or any other MagTek
InSpec 9000-2005 Manual.
vers or guards that are fastened with screws. There are not operator-serviceable areas
within these covers.
Override or “cheat” electrical or mechanical interlock devices.
Use supplies or cleaning materials for other than their intended purposes.
Operate the equipment if unusual noises or odors are noticed.
onsider the following before operating the InSpec 9000-2005:
operly grounded power source receptacle. If in doubt, have the receptacle checked
by a qualified electrician.
Improper connection of the equipment grounding conductor can result in risk of electrical shock.
Locate equipment on a solid support surface with adequate strength for the weight of the machine.
Be careful in moving or relocating the equipment. Use the proper lifting techniques.
Use of unsuitable materials may
result in poor performance and can possibly create a hazardous situation.
This product has been evaluated, tested, and certified by the Canadian Standards Association (CSA 22.2), No.
950, and Underwriters Laboratories (UL1950). In order to insure that it maintains the safety integrity that was
designed into the product, and for which it has been evaluated by the S
w
N
• Use a grou
• Attempt any maintenance fu
• Remove any of the co
•
•
•
C
• Connect equipment to a pr
•
•
•
• Use materials and supplies specifically designed for MagTek equipment.