MagTek InSpec 9000-2005 - Manual (Page 16)

InSpec 9000-2005 Encoded Card Tester
6
SETUP
To setup the unit for operation, perform the following steps:
1.
From the Windows Program Manager, open the InSpec 9000-2005 program. (If more
details are required for opening the program, refer to the next section, Operation.)
2.
After the main menu appears, click on the Read Card button. If the unit is not set up, a
dialog box will appear stating that the setup was not found. This is normal when ever the
software starts up with a new InSpec 9000 reader. If the message states that the InSpec
9000 device was not found, there is no communications between the PC and the InSpec
9000 reader. Check the com cable and the power cable. Recheck the above instructions in
the hardware section for proper hardware installation.
3. From the Main Menu select Setup, select Read Setup Card, and the follow the on screen
instructions for inserting the setup card. Ensure that the Unit ID number on the card
matches the number requested by the software.
The Unit ID number is a unique number for that unit that also identifies the firmware. If
a problem exists with the unit, this number will be needed by technical support personnel.
4.
When the setup if finished, a message will notify the user that the setup was successful.