Aalborg PWE Digital - Manual (Page 74)

69
COMMAND
NAME
DESCRIPTION
NO.
COMMAND SYNT
A
X
COMMAND
ARGUMENT 1
ARGUMENT 2
ARGUMENT 3
ARGUMENT 4
RESPONSE
Maintenance Ti
m
er
Hours since last time unit was calibrated. NOTE: has to be reset to zero after calibration.
14
C
R (read timer)
CR:<value>
Z (set timer to zero)
CZ
Pulse Measure Inter
val
Display/Change Meter Pulse Measure Inter
val settings
Note: Pulse Measure Inter
val
has to be in the range: 500mS
MI
60000 mS
15
I
<new value> in mS
I:<value> Example: I:2000
No Argument (Returns Current MI settings in mS)
I:<value> Example: I:2000
Flow Measure Mode
Display/Change Meter Flow Measuring Mode Following measurement modes are supported: W -
P
ulse Width
C -
Number of Pulses per measure inter
val
16
MM
<New Mode> W - Pulse Width* C - # of Pulses
MM:<value> Example: MM:W
No Argument (Returns Current settings)
MM:<value> Example: MM:W
Flow Meter Linearizer
Enable/Disable flow meter Linearizer
17
FL
<New V
alue>
E or D
FL:<value> Example: FL:E
No Argument (Returns Current Linearizer settings)
FL:<value> Example: FL:E
LCD Back Light**
Display/Change LCD Back Light settings Note: LCD Back Light settings has to be in the range: 0
%
B
L
8
0
%
18
BL
(New LCD Back Light value) 0 - 80%
BL: <BL V
alue>
Example: BL:50
No Argument (Returns Current LCD Back Light settings)
BL: < BL V
alue >
Example: BL:50