Aalborg PWE Digital - Manual (Page 79)

74
INDEX NAME DATA TYPE NOTES
33 TotalFlowStart float Start Main Totalizer at flow [%FS] 0 - Disabled
34 TotalVolStop float
Main Totalizer Action Limit Volume [%*s]
0- Disabled
35 TotalConfLock uint
Key Pad Totalizer reset access Lock [0 – Disabled, 1
– Enabled]
36 UDUnitKfactor float K-Factor for User Defined Units of Measure
37 UDUnitTimeBase int K-Factor = UDUnit/(L/min)
38 UDUnitDensity uint User Defined Unit Time Base [1, 60, 3600 sec]
39 FoutScaleV float
User Defined Unit Density Flag
[0-not used, 1 - used]
40 FoutOffsetV float Flow Analog 0-5 Vdc Out Scale
41 FoutScalet_mA float Flow Analog 0-5 Vdc Out Offset
42 FoutOffset_mA float Flow Analog 4-20 mA Out Scale
43 ToutScaleV float Temperature Analog 0-5 Vdc Out Scale**
44 ToutOffsetV float Temperature Analog 0-5 Vdc Out Offset**
45 ToutScalet_mA float Temperature Analog 4-20 mA Out Scale**
46 ToutOffset_mA float Temperature Analog 4-20 mA Out Offset**
47 FlowMeasureMode uint
0-Pulse width measure, 1 - Number of Pulses per
measure interval
48 OptOut1_Config uint Optical Output #1 Configuration (function) [0-10]
49 OptOut2_Config uint Optical Output #2 Configuration (function) [0-10]
50 RTD_LinearMode uint RTD Linearizer (0-Disabled, 1-Enabled)**
51 AlarmLatch uint Alarm Latch settings [0-3]
52 PTotalMode uint Pilot Totalizer mode (0-Disabled, 1-Enabled)
53 Reserved uint Reserved
54 PTotalFlowStart float Start Pilot Totalizer at flow [%FS] 0 - Disabled
55 PTotalVolStop float
Pilot Totalizer Action Limit Volume [%*s]
0-Disabled
56 MeterFSRange float Meter Full Scale range in L/min
57 LowFlowCutOff float
Low Flow cut off. Must be between 0 and 10.0
%F.S.
58 Damping uint Flow Reading Damping 1-99 seconds
59 Density float Fluid Density g/cm3 [0.01 - 5.00000 g/cm3]
60 PulseMeasInt uint Flow Pulse Measure Interval in mS [500-60000]
61 MeterCalFactor uint Calibration Factor:Number of Pulses per Gallon
62 FlowTbl[0].FlowPFS float Flow Linearizer Index 0 PFS (must be 0.0)
63 FlowTbl[0].LinCounts uint Flow Linearizer Index 0 Counts (must be 0)
64 FlowTbl[1].FlowPFS float Flow Linearizer Index 1 PFS [0.0 – 1.0]
65 FlowTbl[1].LinCounts uint Flow Linearizer Index 1 Counts
66 FlowTbl[2].FlowPFS float Flow Linearizer Index 2 PFS [0.0 – 1.0]
67 FlowTbl[2].LinCounts uint Flow Linearizer Index 2 Counts