Campbell Scientific NL200/NL201 Network Link Interface User Manual
Page 17
NL200/201 Network Link Interface
Campbell Scientific’s LoggerNet software is used to communicate with the
dataloggers once the NL200/201 is configured properly and connected to a
network.
Bridge Mode
•
Allows access to datalogger’s internal IP functionality when a peripheral
port is not accessible. For example accessing the HTTP/webpage, email,
and FTP capabilities of a CR800/850, ET107, RAWS, or CS110.
Serial Server
•
Allows access to a CR10X over Ethernet (RS-232 serial server) when used
in conjunction with an RS-232 to CS I/O (ME) adapter like the SC32B or
SC105.
•
Allows access to a serial sensor over Ethernet (RS-232 serial server).
•
Provides an Ethernet to RF500M Base. (RS-232 serial server).
PakBus® Router
•
Allows access to a CR10X-PB over Ethernet.
•
Allows access to a CR200X over Ethernet.
•
Allows you to connect to a PakBus® Device on the RS-232 port and a
PakBus Device on the CS I/O port using only one TCP port.
•
Allows a PakBus® device on the RS-232 port and a PakBus device on the
CS I/O port to communicate with each other without routing through the
Ethernet.
•
Allows multiple computers to concurrently talk to PakBus® devices
connected to the RS-232 and CS I/O ports.
TLS Proxy Server
•
Adds an encrypted Ethernet network interface to a datalogger that supports
CS I/O IP (bridge mode) communications.
7