4 configuring the nl200/201 via rs-232, Operation, 1 pakbus® router – Campbell Scientific NL200/NL201 Network Link Interface User Manual

Page 21: Configuring the nl200/201 via rs-232, Pakbus® router

Advertising
background image

NL200/201 Network Link Interface

Type

edit and press Enter to edit the settings of the NL200/201.

As each NL200/201 setting is shown, press Enter to accept the current

value shown in parenthesis. Type a new value and press Enter to change

the value.

After progressing through all of the NL200/201 settings, type

save to

accept the changes or

cancel to discard the changes.

Type

bye to exit Telnet.

6.4 Configuring the NL200/201 via RS-232

Accessing the configuration terminal menu via RS-232 requires

the NL200/201 to be power cycled, so physical access to the

device will be required. A null modem serial cable will be needed;

one is not provided with the NL200/201.

Using a null modem serial cable, connect your computer’s serial port to

the port labeled “RS-232” on the NL200/201.

Connect to the NL200/201 using a terminal emulator. DevConfig’s

“unknown” device type or HyperTerminal are examples of simple terminal

emulators. The default settings for this interface are 115200 baud, 8 stop

bits, no parity, 1 stop bit, no flow control.

Power cycle the NL200/201 and repeatedly press Enter at the terminal.

Type

help to see a list of the functionality available when connected to the

NL200/201 through Telnet.

Type

edit and press Enter to edit the settings of the NL200/201.

As each NL200/201 setting is shown, press Enter to accept the current

value shown in parenthesis. Type a new value and press Enter to change

the value.

After progressing through all of the NL200/201 settings, type

save to

accept the changes or

cancel to discard the changes.

Disconnect your computer and power cycle the NL200/201.

7. Operation

This section describes how to configure your NL200/201 for different

operational modes. See Section 4, Overview, for help in determining which

mode to use.

7.1 PakBus® Router

When the RS-232 or CS I/O port is configured as a PakBus® router, the

NL200/201 can route packets to other devices in the network that it has in its

NOTE

11

Advertising