Allied Telesis AT-9000 Series - Manual (Page 158)

Chapter 14: Power Over Ethernet (PoE)
158
Displaying PoE Settings
To display the switch Spanning Tree Protocol settings do the following:
1. Hover the cursor over the Switching tab.
The Switching tab is displayed. See Figure 20 on page 59.
2. From the Switching tab drop-down menu, select PoE.
The PoE page is displayed. See Figure 55.
Figure 55. PoE Page
The following fields are displayed:
 Status— Indicates if PoE is enabled or disabled globally.
 Power Usage Threshold— Threshold of the switch’s total
available system and PoE power. An SNMP trap is transmitted if
the requirements of the PDs exceed the threshold.
 Interface— Port ID.
 Description— Description of the PoE device connected to the
port.
 PoE Status— Indicates if PoE is enabled or disabled on a specific
port.