Allied Telesis AT-9000 Series - Manual (Page 222)

Chapter 19: Setting LLDP and LLDP-MED
222
The Modify LLDP Port Configuration page is displayed. See Figure 83.
Figure 83. Modify LLDP Port Configuration Page
4. Change the settings as needed.
The definitions are listed in Step 2. Click on the box next to the field to
select it.
Note
You cannot modify the port ID from this page. To change this field,
go to the previous page (Figure 82, “LLDP Port Config Page” on
page 221) and select Edit next to the port you want to modify.
5. Click Apply.
6. Click SAVE.
Assigning Port
Locations
A port location is assigned to a Civic, Coordinate, or ELIN location ID. You
must create these IDs before you assign a port location. For instructions,
see “Setting LLDP Locations” on page 211.
To assign an LLDP port location, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73 on page
211.