Allied Telesis AT-9000 Series - Manual (Page 228)

Chapter 19: Setting LLDP and LLDP-MED
228
Enabling LLDP-
MED TLV
To enable LLDP-MED TLV, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73 on page
211.
2. From the Discovery & Monitoring tab, hover over LLDP and then
hover over TLV.
The LLDP TLV tab is displayed. See Figure 86 on page 225.
3. From the LLDP TLV tab, select TLV-MED on the right
The LLDP MED TLV page is displayed. See Figure 89.
Figure 89. LLDP MED TLV Page
The following fields are displayed:
 Interface— Port number.
 Capabilities— Device’s router and bridge functions, and whether
or not these functions are currently enabled.
 Network-policy— Network policy information configured on the
port for connected media endpoint devices. The switch supports
Application Type 1: Voice, including the following network policy
for connected voice devices to use for voice data:
- Voice VLAN ID
- Voice VLAN Class of Service (CoS) priority