Allied Telesis AT-9000 Series - Manual (Page 211)

AlliedWare Plus Version 2.1.8 Management Software Web Interface User’s Guide
211
Setting LLDP Locations
Creating LLDP locations lets you create IDs that are then used in following
procedures. The procedures in this section allow you to create LLDP Civic,
Coordinate, and Emergency Location Identifier Number (ELIN) locations.
See the following:
 “Creating a Civic Location”
 “Creating a Coordinate Location” on page 215
 “Creating an ELIN Location” on page 217
Creating a Civic
Location
To create an LLDP Civic Location, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73.
Figure 73. Discovery & Monitoring Tab
2. From the Discovery & Monitoring tab, hover over LLDP.
The LLDP tab appears on the right.
3. From the LLDP tab, move the cursor to the right and hover over
Locations.
The Locations tab is displayed. See Figure 74 on page 212.