Allied Telesis AT-9000 Series - Manual (Page 1102)

Chapter 68: LLDP and LLDP-MED Commands
1074
LLDP TX-DELAY
Syntax
lldp tx-delay tx-delay
Parameters
tx-delay
Specifies the transmission delay timer in seconds. The range is 1
to 8192 seconds.
Mode
Global Configuration mode
Description
Use this command to set the value of the transmission delay timer. This is
the minimum time interval between transmissions of LLDP advertisements
due to a change in LLDP local information. The transmission delay timer
cannot be greater than a quarter of the transmit interface, set with “LLDP
TIMER” on page 1069. To view the current value, refer to “SHOW LLDP”
on page 1091.
Confirmation Command
“SHOW LLDP” on page 1091
Example
This example sets the transmission delay timer to 120 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# lldp tx-delay 120