Allied Telesis AT-9000 Series - Manual (Page 433)

405
Chapter 24
IGMP Snooping Commands
The IGMP snooping commands are summarized in Table 41 and are
described in detail within the chapter.
Table 41. Internet Group Management Protocol Snooping Commands
Command Mode Description
“CLEAR IP IGMP” on page 406 Privileged Exec Clears all IGMP group membership
records.
“IP IGMP LIMIT” on page 407 Global
Configuration Specifies the maximum number of
multicast addresses the switch is
allowed to learn.
“IP IGMP QUERIER-TIMEOUT” on
page 408 Global
Configuration Specifies the time period in seconds
used by the switch to identify inactive
host nodes and multicast routers.
“IP IGMP SNOOPING” on page 409 Global
Configuration Enables IGMP snooping on the
switch.
“IP IGMP SNOOPING FLOOD-
UNKNOWN-MCAST” on page 410 Global
Configuration Disables the automatic suppression of
unknown multicast traffic.
“IP IGMP SNOOPING MROUTER” on
page 412 Global
Configuration Manually identifies the ports where
multicast routers are connected.
“IP IGMP STATUS” on page 413 Global
Configuration Specifies the IGMP host node
topology, of either single-host per port
or multiple-host per port.
“NO IP IGMP SNOOPING” on
page 414 Global
Configuration Disables IGMP snooping on the
switch.
“NO IP IGMP SNOOPING
MROUTER” on page 415 Global
Configuration Removes multicast router ports.
“SHOW IP IGMP SNOOPING” on
page 416 Privileged Exec Displays the parameter settings and
operational details of IGMP snooping.