Allied Telesis AT-9000 Series - Manual (Page 315)

AT-9000 Switch Command Line User’s Guide
287
NO IPV6 ADDRESS
Syntax
no ipv6 address
Parameters
None
Mode
VLAN Interface mode
Description
Use this command to delete the current IPv6 management address from
the switch. You must perform this command from the VLAN Interface
mode of the VLAN to which the address is attached.
Note
The switch uses the IPv6 management address to perform the
features listed Table 26 on page 258. If you delete it, the switch will
not support the features unless it also has an IPv4 management
address.
Confirmation Command
“SHOW IPV6 INTERFACE” on page 292 and “SHOW IPV6 ROUTE” on
page 293
Example
This example removes the static IPv6 management address from the
VLAN with the VID 3:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan3
awplus(config-if)# no ipv6 address