Allied Telesis AT-9000 Series - Manual (Page 925)

AT-9000 Switch Command Line User’s Guide
897
AUTH GUEST-VLAN
Syntax
auth guest-vlan vid
Parameters
vid
Specifies the ID number of a VLAN that is the guest VLAN of an
authenticator port. You can enter just one VID.
Mode
Port Interface mode
Description
Use this command to specify the VID of the VLAN that acts as the guest
VLAN of an authenticator port. An authenticator port remains in a guest
VLAN until a supplicant successfully logs on, at which point it is moved to
the VLAN specified in a supplicant’s account on the RADIUS server. A port
must already be designated as an authenticator port before you can use
this command.
To remove the VID of a guest VLAN from an authenticator port, refer to
“NO AUTH GUEST-VLAN” on page 919.
Example
This example designates ports 1 to 4 as authenticator ports and specifies
VID 12 as the guest VLAN:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.4
awplus(config-if)# dot1x port-control auto
awplus(config-if)# auth guest-vlan 12