Allied Telesis AT-9000 Series - Manual (Page 917)

AT-9000 Switch Command Line User’s Guide
889
Displaying EAP Packet Statistics
To display EAP packet statistics of authenticator ports, use the SHOW
DOT1X STATISTICS INTERFACE command or the SHOW AUTH-MAC
STATISTICS INTERFACE command. Both commands display the same
information. Here is an example of the information. This example displays
the authenticator settings for port 2:
awplus> enable
awplus# show dot1x statistics interface port1.0.2
Figure 157. SHOW DOT1X STATISTICS INTERFACE Command
Authentication Statistics for interface port1.0.2
EAPOL Frames Rx: 0 - EAPOL Frames Tx: 0
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 0 - EAP Response Frames Rx: 0
EAP Req/Id Frames Tx: 0 - EAP Request Frames Tx: 0
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 0 - EAPOL Last Frame Src: 0000.0000.0000