Allied Telesis AT-9000 Series - Manual (Page 984)

Chapter 63: SNMPv1 and SNMPv2c Commands
956
SHOW SNMP-SERVER
Syntax
show snmp-server
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the current status of SNMP on the switch. An
example is shown in Figure 170. The first field displays whether SNMP is
enabled or disabled on the switch. You can remotely manage the switch
with SNMPv1 or v2c when the server is enabled. Remote management is
not possible when the server is disabled. To activate or deactivate SNMP,
refer to “SNMP-SERVER” on page 960 and “NO SNMP-SERVER” on
page 947, respectively.
Figure 170. SHOW SNMP-SERVER Command
Example
This example displays the current status of SNMP on the switch:
awplus# show snmp-server
SNMP Server ....... Enabled
IP Protocol ....... IPv4
SNMPv3 Engine ID (Configured) ........ Not set
SNMPv3 Engine ID (actual) ............ 0x80001f8880241d7f08386d438e