Allied Telesis AT-9000 Series - Manual (Page 712)

Chapter 46: MSTP Commands
684
REVISION
Syntax
revision <revision-number>
Parameters
revision-number
Specifies the revision number. The range is 0 to 255.
Mode
MST Configuration mode
Description
Use this command to specify the revision number of the current MST
configuration. This value is an arbitrary value that you assign to an MST
region. Use the revision number to track the number of times an MST
configuration has been updated on the network.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 130
“SHOW SPANNING-TREE” on page 669
Example
This example specifies the MST revision number as 4:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mst enable
awplus(config)# spanning-tree mst configuration
awplus (config-mst)# revision 4