Allied Telesis AT-S95 CLI - Manual (Page 101)

Ethernet Configuration Commands
Page 89
User Guidelines
The command is effective only after reset.
Example
The following example enables jumbo frames for the device.
system flowcontrol
Use system flowcontrol Global Configuration mode to enable flow control on cascade ports. Use the no form of
this command to disable it.
Syntax
system flowcontrol
no system flowcontrol
Default Configuration
This command has no default configuration.
Command Mode
GLOBAL Configuration mode
User Guidelines
There are no user guidelines for this command.
clear counters
The clear counters User EXEC mode command clears statistics on an interface.
Syntax
clear counters [ethernet interface | port-channel port-channel-number]
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
• port-channel-number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Console(config)# port jumbo-frame