Allied Telesis AT-S95 CLI - Manual (Page 297)

VLAN Commands
Page 285
Default Configuration
1
Command Mode
VLAN Configuration mode
User Guidelines
There are no user guidelines for this command.
Note
After running the command, the device must be reset.
Example
interface vlan
The interface vlan Global Configuration mode command enters the Interface Configuration (VLAN) mode.
Syntax
interface vlan vlan-id
Parameters
•
vlan-id — Specifies an existing VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
In case the VLAN doesn't exist (‘ghost VLAN’), only partial list of the commands are available under the interface
VLAN context.
The commands supported for non-existant VLANs are:
1) IGMP snooping control
2) Bridge Multicast configuration
console(config-vlan)# default-vlan vlan 1
console(config-vlan)#