Nikon COOLSHOT User Manual
Page 15
28
29
En
Jp
Fr
Es
Pt
Ru
Se
Nl
De
It
Dk
Pl
Hu
Cz
Fi
No
Ro
En
Jp
Fr
Es
Pt
Ru
Se
Nl
De
It
Dk
Pl
Hu
Cz
Fi
No
Ro
Internal display
Distance
Unit of measure (m/yd.)
Target mark
Laser irradiation mark
Height
(Actual distance at Golf mode setting)
Battery condition
Incline
Decline
First Target Priority mode
Distant Target Priority mode
Measurement display mode
1. Turn on the power (Confirm the internal display
is on).
2. Press and hold the MODE button, then
immediately (less than 0.5 second) depress the
POWER ON/Measurement button for less than 2
seconds.
3. Release your finger from the POWER
ON/Measurement button to switch the
Measurement display mode.
4. Repeat steps 2 and 3 until your desired mode is
displayed.
* If the buttons are not pressed in the correct
order, switching will not take place.
* Switching the mode after measurement
converts the results to the new mode.
* After the mode is set, measurements are
performed in the new mode.
Press and hold the MODE button, then immediately depress the POWER ON/Measurement button (less
than 2 seconds) to change the mode in the order shown below.
Actual Distance
and Height Mode
Horizontal Distance
and Height Mode
Golf Mode
Actual Distance
Mode
Actual
Distance
Height
Horizontal
Distance
Height
Slope
Adjusted
Distance
Actual
Distance
Actual
Distance
『
』 - Aim at the target you want to measure. Position the target at the center of the reticle.
『
』 - Appears while the laser is being irradiated for a measurement.
Remains present during single measurement. Blinks during continuous measurements.
Do not look into the objective lens while this mark is shown.
『 』 - Now measuring
『
』 - "Failure to measure" or "Unable to measure"
* Usually, an LCD employs equal or lower magnification. However the LCD of this product is magnified
by the high magnification of the eyepiece. Although this LCD was produced using the most advanced
technology, it is impossible to eliminate dust completely. As a result, dust may be seen. It will not,
however, affect measurement accuracy or safety during use.